User Tools

Site Tools


network_space_v2

This is an old revision of the document!


LaCie Network Space v2

This page is relevant for Network Space (Max) v2 and Internet Space v2 boards.

Hardware

  • CPU ARM926EJ-S (ARMv5TE) 800MHz
  • SoC Kirkwood 88F6281_A0
  • SDRAM memory 256MB, DDR2 533MHz
  • SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G)
  • Ethernet Gigabit port (PHY MARVELL 88E1116R)
  • 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2)
  • 1 SATA port (2 ports for Network Space Max v2)
  • I2C EEPROM, 512 bytes (24C04 type)
  • 2 LEDs (blue and red with CPLD SATA activity blink)
  • Power push button

Network Space v2 Network Space v2

Openocd

An unreliable configuration is available here

U-Boot

The boards are almost fully supported mainline. For more informations, see our U-Boot main page

Here are the remaining tasks:

  • Initialize MAC address from I2C EEPROM.
  • Merge patch “sf: macronix: disable write protection when initializing” with mainline.
  • Configure GPIO LEDs.
  • Enhance the default boot sequence (environment variables).

Linux

The boards are almost fully supported mainline. For more informations, see our Linux for Kirkwood main page.

Userspace

network_space_v2.1310762046.txt.gz · Last modified: 2011/07/15 20:34 by simon