This is an old revision of the document!
LaCie Network Space v2
This page is relevant for Network Space (Max) v2 and Internet Space v2 boards.
Since mid-2011 lacie change the hardware configuration of the network space v2 to a lower one, see LaCie Network Space Lite v2.
CPU ARM926EJ-S (ARMv5TE) 800MHz
SoC Kirkwood 88F6281_A0
SDRAM memory 256MB, DDR2 267MHz
SPI flash, NOR 512kB (MACRONIX MX25L4005CMI-12G)
Ethernet Gigabit port (PHY MARVELL 88E1116R)
1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2)
1 SATA port (2 ports for Network Space Max v2)
I2C EEPROM, 512 bytes (24C04 type)
2 LEDs (blue and red with CPLD SATA activity blink)
Power push button
An unreliable configuration is available here
The boards are almost fully supported mainline. For more informations, see our U-Boot for Kirkwood page.
The boards are almost fully supported mainline. For more informations, see our Linux for Kirkwood page.
It is also possible to install Debian, look here.
For more informations about the LaCie stock system, look here.